Roof Underlayment Explained: Step-by-Step Guide

When you are planning a roof replacement in Metro Detroit, the shingles usually get all the attention. However, the layer directly underneath the shingles is arguably more critical for the long-term waterproofing of your home. This roof underlayment explained step-by-step guide will walk you through exactly what this material is, why it matters in Michigan’s climate, and how a professional crew installs it to ensure your home stays dry.

Underlayment acts as the secondary barrier against water intrusion. If wind-driven rain gets under the shingles—or if ice dams form in the winter—the underlayment is what stops the water from rotting your roof deck. At Best Choice Roofing, we treat underlayment as a non-negotiable component of the system, not an optional add-on.

Why Underlayment is Critical in Michigan

Before we get into the installation steps, it is important to understand why we emphasize this material. In Wayne, Oakland, and Macomb counties, we deal with freeze-thaw cycles, heavy snow loads, and severe thunderstorms.

Standard shingles are designed to shed water, but they are not waterproof membranes. Wind can lift shingles, and ice can force water up the roof slope. Without a high-quality underlayment, that water seeps into the plywood sheathing. Once the wood gets wet, mold and rot follow quickly.

For a deeper dive into the specific types and composition of these materials, you can read our detailed breakdown on roof underlayment explained.

Step 1: Deck Preparation and Inspection

The installation of a waterproofing barrier is only as good as the surface it sits on. We never roll out underlayment over a damaged or dirty deck.

  1. Remove Old Materials: After the tear-off, the crew removes all old nails, staples, and debris from the roof deck.
  2. Inspect the Sheathing: We look for sections of plywood or OSB that are soft, water-damaged, or rotting. In Metro Detroit, we often find deck damage around chimneys and valleys where previous leaks occurred. Any compromised wood is replaced before we proceed.
  3. Renail the Deck: To ensure structural integrity and prevent "nail pops" later, we renail the sheathing according to code. This secures the wood firmly to the trusses.

Step 2: Installing Ice and Water Shield

This is the most vital step for homes in Detroit. Ice and water shield is a self-adhering, rubberized membrane that sticks directly to the roof deck. It creates a watertight seal around nails that penetrate it.

Step 3: Rolling Out Synthetic Underlayment

Once the critical leak-prone areas are sealed with ice and water shield, we cover the rest of the roof deck with synthetic underlayment. Modern contractors have largely moved away from traditional asphalt-saturated felt (tar paper) in favor of synthetics.

Synthetic underlayment is lighter, stronger, and more resistant to tearing. It also holds up better if it gets wet before we install the shingles, which is a common occurrence during unpredictable Michigan spring weather.

  1. Positioning the Roll: We start at the eave and roll the material up the slope, parallel to the gutter.
  2. Alignment: The bottom edge of the underlayment must overhang the drip edge slightly. This ensures water runs off the roof and into the gutter, not behind the fascia.
  3. Fastening: We use cap staples or roofing nails with plastic caps to secure the material. These caps prevent the nail head from tearing through the paper during high winds. We follow a specific nailing pattern, typically placing fasteners every 6 to 12 inches along the edges and in the field.

Step 4: Overlapping and Layering

Water flows downhill. Therefore, roofing materials must be installed in a "shingle fashion"—upper layers must overlap lower layers.

Proper lapping ensures that if water gets past the top layer of shingles, it will hit the underlayment and continue running down the roof rather than slipping through a seam.

Step 5: Flashing Integration

Underlayment does not sit in isolation; it must integrate with the metal flashing components.

Step 6: Final Inspection Before Shingles

Before a single shingle is nailed down, a site supervisor from Best Choice Roofing walks the entire roof. We check for: * Wrinkles or bubbles in the synthetic material (which can telegraph through the shingles or trap water). * Exposed areas where the deck is visible. * Proper fastening patterns.

Once the underlayment passes inspection, we are ready for the shingles. While the shingles provide the aesthetic appeal and the primary sun protection, the underlayment is the engine room of your roof's defense system.

Maintaining Your Roofing Materials

While underlayment is hidden, its performance depends on the condition of the shingles above it. Once shingles curl, crack, or go missing, the UV rays and weather will quickly degrade the exposed underlayment. This is why we recommend regular inspections, especially after major storm events.

If you have noticed leaks in your attic or stains on your ceiling, the underlayment may have failed. This often happens due to age or storm damage.

Get a Professional Assessment

Understanding the installation process helps you make informed decisions, but climbing onto a roof to check the underlayment yourself is dangerous and unnecessary. At Best Choice Roofing, we provide free inspections and upfront pricing. We will tell you exactly what is happening under your shingles.

We are a licensed, insured Metro Detroit roofing crew serving Wayne, Oakland, Macomb, and surrounding Michigan counties. We offer same-day response on active leaks and full insurance-claim help if your roof has been damaged by a recent storm.

Since every roof is unique, we never quote a firm price online. A roofer needs to confirm the exact scope of work, deck condition, and material choices after a thorough inspection.

If you want to ensure your home is protected with the best roofing materials and installation practices, call us today.

CTA BLOCK

Protect Your Home from the Inside Out

Don't wait for a leak to discover your roof's defense system is failing. Best Choice Roofing provides honest, professional assessments for homeowners across Metro Detroit.

Call (248) 206-5958 or request a free inspection at roofs.bestchoice411.com.